©2014 Edelbrock LLC
Part #1574, 1575, 1576
Brochure #63-1574
Rev. 9/24/14 - QT
Edelbrock GM LS3 Supercharger System for
2010 and later Grand Sport Corvettes
Installation Instructions
Page 3
91 octane or higher gasoline is required at all times. If your vehicle has been
filled with anything less, it must be run until almost dry and refilled with 91 or
higher octane gasoline twice prior to installation.
Failure to use the required 91 octane gasoline or higher could permanently
damage your engine. Any failures associated with not using premium 91 octane
gasoline or higher, will be ineligible for warranty repairs.
IMPORTANT WARNINGS (CONTINUE)
Any equipment that directly modifies the fuel mixture or ignition timing of the engine can cause severe engine damage if
used in conjunction with the Edelbrock E-Force Supercharger System. This includes, but is not limited to: ignition boxes,
air/fuel controllers, OBDII programmers, and any other device that modifies signals to and/or from the ECU. Aftermarket
bolt-on equipment such as underdrive pulleys or air intake kits will also conflict with the operation of the supercharger
and must be removed prior to installation. Use of any of these products with the E-Force Supercharger could result in
severe engine damage.
Any previously installed aftermarket tuning equipment must be removed and the vehicle returned
to an as stock condition before installing the supercharger.
Edelbrock periodically releases improved versions of the calibration file found on the supplied handheld
programmer. Check the website, www.edelbrock.com, to ensure you have the latest version, as described in
the PCM Flashing Procedure on Page #10.
It is also recommended that you check the Edelbrock Tech Center Website for any updates to this installation
manual. Please refer to the lower right hand corner to verify that you have the latest revision of this
installation manual before beginning the installation.
Tech Center: http://www.edelbrock.com/automotive_new/misc/tech_center/install/index.php
EDELBROCK AUTHORIZED INSTALLER DISCLAIMER
Authorized installers of Edelbrock products are independent companies over which Edelbrock has no right of control. Edelbrock
LLC makes no claims regarding the abilities, expertise or competency of individual employees of any authorized installer. Each
authorized installer is an independent company and makes its own independent judgments. Edelbrock LLC specifically disclaims any
responsibility to any party including third parties for the actions, or the failure to act, of individuals, agents or a company authorized in
the installation of Edelbrock LLC products.
(5 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais