Edelbrock 2010 Manual de Instalação descarregar pdf (Página 11)

Part #1596, 1597, 1598, 1599

Brochure #63-1598

Rev. 9/19/14 - QT/mc

Edelbrock E-Force Supercharger System

2010-2014 Camaro SS

Installation Instructions

Page 9

17. Lift the protective cover then use a 10mm socket to

loosen and remove the positive battery terminal.

18. Lift and support the front end of the vehicle using a

service lift or jack and appropriately load rated jack stands

then loosen and remove the lug nuts from both front wheels.

Remove the wheels and set them aside.

19. Use a T20 Torx wrench to remove the three bolts on each

side holding the front and the two holding the rear of the

front wheel fender liners. Use a panel puller to remove the

five body pins on each side that retain the inner fender wells

then remove them and set them aside.

20. Reach in through the wheel wells with a 10mm socket

to remove the four bolts at the front of each side of the

fascia then use a 7mm socket to remove the two bolts on

each side of the front fascia.

21. Disconnect the fog lamp electrical connectors and the

fascia wiring harness connector on the passenger side.

22. Use a 10mm socket to remove the two bolts retaining

the bottom of the fascia.

23. Use a panel puller to remove the six body pins holding

the top of the fascia then use a 10mm socket to remove the

bolt at each end of the top of the fascia.

24. The front fascia can now be removed by pulling it

forward off the vehicle. Set front fascia aside.

25. Remove the oil fill cap and remove the plastic engine

cover. Reinstall the oil fill cap.

26. Disconnect the Mass Airflow Sensor connector.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Sem comentários

Edelbrock 2010 Manual de Instalação Página 11